Assembleon Opal-XII
Voor meer informatie omtrent voorraad en prijzen, klik hier.
Assembleon Opal-XII in zeer goede conditie.
Bouwjaar: 2006
Features:
• On the fly alignment using a vision system with a Line Array Camera standard equipped with a side illumination unit for BGA’s, µBGA, CSP components.
• Placement beam with 4 Super Fine heads.
• Simultaneous picking is possible by all 4 heads from any mix of tape feeders (except for 0201 components). This allows a much higher nominal placement rate and board throughput.
• Complete component range can be handled with only 6 nozzles shapes.
• Fiducial alignment camera with improved software controlled illumination unit (white + IR Leds), that also can be used as teaching/tracing device and for Bad Mark sensing.
• Automatic width adjustment. The PCB dimension is included in your PCB data.
• PCB pin-positioning. Second pin is easily adjustable for fast changeover.
• PCB push up plate (Z servo controlled )with 12 push up pins, for PCB support. PCB thickness is included in the PCB data.
• Substopper, allowing a second PCB to enter the machine for reducing transport time.
• Exit Substopper, allowing a new PCB to enter the work area of the machine while the downstream machine is still not ready to accept a new PCB.
• 3.5" FDD for backup purposes.
• CD-ROM drive for software installation
• Operation panel with push buttons
• Component dump box.
• CE safety.
• ESD safety.
• Electrical and Mechanical SMEMA.
Voor gedetailleerde specificaties zie foto's 2 en 3.
Voor meer informatie, neem contact met ons op.
| Specificatie | Omschrijving |
|---|---|
| Disclaimer | 0 |
